ENG0003 Professional engineering continuous professional development
Faculty of Engineering
ENG0003 Professional engineering continuous professional development is a 0-credit-point, postgraduate unit from the Faculty of Engineering, offered in 2023 in Semester 1 and Semester 2 at Clayton. It has no prerequisites.
- Credit points
- 0
- Offered in 2023
- Semester 1, Semester 2
- Clayton
- Assessment
- No exam
- 3 tasks
This is the 2023 handbook entry. See the 2027 entry.
Reviews
No reviews yetNo reviews yet. Be the first to review ENG0003.
Requisites
Before ENG0003
Prohibitions
You can't enrol if you have passed any of these.
After ENG0003
No unit lists ENG0003 as a prerequisite in the 2023 handbook.
Enrolment rules
You must be enrolled in course E6011 Master of Professional Engineering
Overview
Continuous professional development (CPD) is a compulsory requirement for all Master of Professional Engineering students. It is part of meeting the Engineers Australia Stage 1 Competency Standard to be a Professional Engineering.
You are required to complete a minimum of 420 hours of professional and engineering-related experiences outside the classroom throughout your study. Your total hours can be made up of a combination of work, volunteer, personal and professional development activities and events. These experiences will allow you to integrate what you are learning in the classroom with real-world practice.
There are two submissions required to complete your CPD. You will complete a written record and skill reflections on your experiences and complete a series of assessment questions in Moodle.
It is your responsibility to find opportunities and participate in experiences, which will help you develop your job searching and organisational skills. Monash will support you to complete your CPD by sending regular communications about opportunities and providing workshops and resources.
See the CPD website for detailed information about the requirements.
Offerings in 2023
| Teaching period | Campus | Mode |
|---|---|---|
| First semester | Clayton | On campus |
| Second semester | Clayton | On campus |
Assessment
- CPD experiences-
- Skills reflection report-
- CPD assessment-
Learning outcomes
When you finish this unit, you should be able to:
- 1
Apply theoretical engineering knowledge outside of the classroom.
- 2
Demonstrate understanding of engineering practice expectations and observe health and safety rules during professional practice experiences.
- 3
Value engineering ethical principles and responsibilities and satisfy professional standards for assigned engineering tasks.
- 4
Demonstrate the ability to communicate engineering tasks to relevant parties and write professional quality technical reports.
- 5
Demonstrate an ability to work independently and to collaborate with colleagues on common tasks effectively.
- 6
Demonstrate the willingness and ability to engage in life-long learning.
Workload and teaching
A minimum of 420 hours of professional practice experience obtained outside of the classroom.
Contacts
- Unit Coordinators
- Dr Prabhakar Ranganathan
- Fatemeh Azhari
- Dr Leonie van 't Hag
- Dr Nemai Karmakar
- Dr Sebastian Thomas
- Chief Examiners
- Dr Sebastian Thomas
Common questions
What are the prerequisites for ENG0003?
ENG0003 has no prerequisites, but enrolment rules apply.
When is ENG0003 offered?
In 2023, ENG0003 runs in Semester 1 and Semester 2 at Clayton.
Does ENG0003 have an exam?
No. ENG0003 has 3 assessment tasks and no exam.